Parameter Description
Note: This parameter is applicable only to FXO interfaces.
Web: Hotline Dial Tone
Duration
EMS: Hot Line Tone Duration
CLI: hotline-dt-dur
[HotLineToneDuration]
Defines the duration (in seconds) of the hotline dial tone. If no
digits are received during this duration, the device initiates a call
to a user-defined number (configured in the Automatic Dialing
table - TargetOfChannel - see Configuring Automatic Dialing on
page 402).
The valid range is 0 to 60. The default is 16.
Notes:
This parameter is applicable to FXS and FXO interfaces.
You can define the Hotline duration per FXS/FXO port using
the Automatic Dialing table.
Web/EMS: Reorder Tone
Duration [sec]
CLI: reorder-tone-duration
[TimeForReorderTone]
For analog interfaces: Defines the duration (in seconds) that the
device plays a busy or reorder tone before releasing the line.
Typically, after playing the busy or reorder tone for this duration,
the device starts playing an offhook warning tone.
For digital interfaces: Defines the duration (in seconds) that the
CAS device plays a busy or reorder tone before releasing the line.
The valid range is 0 to 254. The default is 0 seconds for analog
interfaces and 10 seconds for digital interfaces. Note that the Web
interface denotes the default value (for analog and digital
interfaces) as a string value of "255".
Notes:
The selected busy or reorder tone is according to the SIP
release cause code received from IP.
This parameter is also applicable for ISDN when the
PlayBusyTone2ISDN parameter is set to 2.
This parameter can also be configured in a Tel Profile.
Web: Time Before Reorder
Tone [sec]
EMS: Time For Reorder Tone
CLI: time-b4-reordr-tn
[TimeBeforeReorderTone]
Defines the delay interval (in seconds) from when the device
receives a SIP BYE message (i.e., remote party terminates call)
until the device starts playing a reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
Web: Cut Through Reorder
Tone Duration [sec]
CLI: cut-thru-reord-dur
[CutThroughTimeForReOrde
rTone]
Defines the duration (in seconds) of the reorder tone played to the
PSTN side after the IP call party releases the call, for the Cut-
Through feature. After the tone stops playing, an incoming call is
immediately answered if the FXS is off-hooked (for analog
interfaces) or the PSTN is connected (for digital interfaces).
The valid values are 0 to 30. The default is 0 (i.e., no reorder tone
is played).
Note: To enable the Cut-Through feature, use the
DigitalCutThrough (for CAS channels) or CutThrough (for FXS
channels) parameters.
Web/EMS: Enable Comfort
Tone
CLI: comfort-tone
[EnableComfortTone]
Determines whether the device plays a comfort tone (Tone Type
#18) to the FXS/FXO endpoint after a SIP INVITE is sent and
before a SIP 18x response is received.
[0] Disable (default)
[1] Enable
Note: This parameter is applicable to FXS and FXO interfaces.
[WarningToneDuration]
Defines the duration (in seconds) for which the offhook warning
To Next Page
Loading...
