AudioCodes Media 800 MSBR - Page 958

User's Manual 958 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
manipulation of the original calling party number, using the
Tel2IPSourceNumberMappingDialPlanIndex parameter), but before
the regular calling or redirect number manipulation:

If a redirect number exists, it replaces the calling party number.
If there is no redirect number, the calling number is left
unchanged.

If there is a calling “display” name, it remains unchanged.

The redirect number remains unchanged and is included in the
SIP Diversion header.
Web/EMS: Add Trunk
Group ID as Prefix
CLI: trkgrpid-prefix
[AddTrunkGroupAsPrefix]
Determines whether the Trunk Group ID is added as a prefix to the
destination phone number (i.e., called number) for Tel-to-IP calls.
 [0] No = (Default) Don't add Trunk Group ID as prefix.
 [1] Yes = Add Trunk Group ID as prefix to called number.
Notes:
 This option can be used to define various routing rules.
 To use this feature, you must configure the Trunk Group IDs (see
Configuring Trunk Group Table on page 295).
Web: Add Trunk ID as
Prefix
EMS: Add Port ID As Prefix
CLI: trk-id-as-prefix
[AddPortAsPrefix]
Determines whether or not the port number / Trunk ID is added as a
prefix to the called (destination) number for Tel-to-IP calls.
 [0] No (Default)
 [1] Yes
If enabled, the device adds the following prefix to the called phone
number: slot number (a single digit in the range of 1 to 6) and port
number / Trunk ID (single digit in the range 1 to 8). For example, for the
first trunk/channel located in the first slot, the number "11" is added as
the prefix.
This option can be used to define various routing rules.
Web/EMS: Add Trunk
Group ID as Prefix to
Source
CLI: trkgrpid-pref2source
[AddTrunkGroupAsPrefix
ToSource]
Determines whether the device adds the Trunk Group ID (from where
the call originated) as the prefix to the calling number (i.e. source
number).
 [0] No (default)
 [1] Yes
Web: Replace Empty
Destination with B-channel
Phone Number
EMS: Replace Empty Dst
With Port Number
CLI: empty-dst-w-bch-nb
[ReplaceEmptyDstWithPo
rtNumber]
Determines whether the internal channel number is used as the
destination number if the called number is missing.
 [0] No (default)
 [1] Yes
Note: This parameter is applicable only to Tel-to-IP calls and if the
called number is missing.
[CopyDestOnEmptySourc
e]
Determines whether the destination number is copied to the source
number if no source number is present, for Tel-to-IP calls.
 [0] = (Default) Source Number is left empty.
 [1] = If the Source Number of a Tel-to-IP call is empty, the
Destination Number is copied to the Source Number.
Web: Add NPI and TON to
Calling Number
EMS: Add NPI And TON As
Prefix To Calling Number
CLI: npi-n-ton-to-cng-nb
Determines whether the Numbering Plan Indicator (NPI) and Type of
Numbering (TON) are added to the Calling Number for Tel-to-IP calls.
 [0] No = (Default) Do not change the Calling Number.
 [1] Yes = Add NPI and TON to the Calling Number ISDN Tel-to-IP