95
Nyquist C4000 User Guide
After the Check-in process has been stopped, all Normal station calls resume as normal calls to the
Admin Station, and the Check-in process Status becomes Idle.
Resetting the Check-In Process
During either an active or idle Check-In process, you can clear all station check-in statuses and allow all
Normal calls to resume as normal calls to the Admin Station by selecting the Reset button on the Sta-
tion Check-in view. You can also reset the Check-In process by a Routine action. When resetting
Check-In via a routine, the Action Type is Check-In and the Check In option is Reset.
Using Spy Mode
You can use Spy Mode to listen to a station as long as Privacy Mode is not enabled and the station
device allows two-way transmission.
This feature adds another step toward verifying that the room’s occupants are safe.
Figure 85. Listen In, or Spy Mode, Button
To activate Spy Mode:
1 If not already on your dashboard, select Dashboard from the navigation bar.
2 Under Calling/Paging, select Manage Check-In.
3 On the Manage Check-In page, select the Listen In icon for the station you want to monitor.
To activate Spy Mode using a DTMF code (regardless of Check-In process):
1 If not already on your dashboard, select Dashboard from the navigation bar.
2 Under Calling/Paging, select Dial Pad.
3 When the dial pad appears, dial 978{station-extension}.
Note: Spy Mode monitoring cannot be used on a station that has been set to Privacy Mode.
To Next Page
Loading...
Need help?
General