131
Installing Certification Authority on an Android Device
Note: The Android device WiFi must be connected to the same network as the Nyquist Server.
To download and install the Certification Authority on an Android device:
1 From your Chrome or Edge browser, type
http://<device>/ssl/bogenCA.crt in the address bar,
where <device> is the Nyquist device’s IP address or DNS name (for example,
http://192.168.1.0/ssl/bogenCA.crt).
2 If prompted, verify your identity (e.g., enter your PIN or fingerprint).
3 Type a certificate name (e.g., “Bogen CA”), specify “VPN and apps” under “Used for”, and select OK
to install the certificate.
Installing Certification Authority on an iOS Device
Note: The iOS device WiFi must be connected to the same network as the Nyquist Server.
To download and install the Certification Authority on an iPhone Operating System (iOS) device:
1 From your Safari browser, type
http://<device>/ssl/bogenCA.crt in the address bar, where
<device> is the Nyquist device’s IP address (for example,
http://192.168.1.0/ssl/bogenCA.crt).
2 Select Go.
3 Select Allow when prompted to allow the download.
4 Select Close after the notification that a profile was downloaded.
5 Select Settings > General > VPN & Device Management.
6 Select the Bogen CA certificate under DOWNLOADED PROFILE.
7 Select Install.
8 If prompted, enter your passcode.
9 On the Warning page, select Install.
10 Select Done.
11 Select Settings > General > About > Certificate Trust Settings.
12 Under ENABLE FULL TRUST FOR ROOT CERTIFICATES, Enable the switch next to Bogen CA.
Viewing the Certificate
The following steps outline how to view and verify the TLS/SSL certificate that was provided by the
Nyquist device.
To Next Page
Loading...