138
Monitoring/Recording
Description DTMF Code Required CoS
Monitor call or location at {extension}
Note: Spy Mode monitoring cannot be used on a station that
has been set to Privacy Mode.
978{extension}
a
Monitor Calls/Locations
Enable “spy mode“ (MUTE) during call monitoring 4 (none)
Enable “whisper mode“ during call monitoring 5 (none)
Enable “barge mode“ during call monitoring 6 (none)
Record Message (Announcement)
*990
a
All-Call Paging
Note: When you record an announcement by dialing *990 or by selecting Record Announcement on the Admin phone’s Announce menu, the initial DTMF Code
for the recorded and saved announcement will be set to the announcement’s row ID. You can change the DTMF Code after the announcement is saved by editing
the announcement in the web interface Announcements view.
The saved announcement has Play to Zone set to blank (no zone selected). This means that when you play an announcement via an IP phone Announcement
menu selection, you will be asked to enter a zone number (where 0 = All Speakers). You can define a permanent zone number for the saved announcement by
updating Play to Zone after the recorded announcement has been saved.
Playback recorded calls
MENU: 1–Emergency, 2–Monitored, 3–Urgent, 4–
Standard
999 Manage Recordings
Start/Stop recording (DTMF used during a call) *3 Record Calls
To Next Page
Loading...