44
Nyquist C4000 User Guide
Viewing Announcements
Through the Announcements page, you can view a list of all announcements that are available for
scheduling, delete an announcement, and select to edit or add an announcement.
Note: The navigation bar does not appear if you are not authorized to make changes to the C4000 con-
figuration. Contact your system administrator or refer to the Nyquist C4000 System Administrator Guide.
Figure 37. Announcements Page
To view a list of all announcements that are available for scheduling:
1 On the navigation bar, expand Audio.
2 Select Announcements.
The following parameters appear for each announcement file:
Table 12. Announcements Page Parameters
Name Displays the user-provided name of the announcement file.
Note: Valid characters include uppercase letters (A–Z), lowercase letters (a–z), numerals
(0–9), space, and the following special characters: !@$*?-.,.
Type Displays if the announcement is a Normal or an Emergency announce-
ment.
DTMF Code Displays the DTMF code used to manually start the announcement via the
dashboard dial pad or IP phone keypad.
Creation Date/Time Displays when the announcement was created.
Created By Displays the extension that is to be considered the source of the
announcement for CoS considerations.
Times to Play Displays the number of times the announcement will play. This number
can range from 0 through 10.
Note: A setting of 0 results in the announcement playing continuously until it is manually
stopped via the dashboard.
Note: Announcements configured for continuous playback should not be used with the
Facility Announcement feature.
Times Between
Repeats (seconds)
Displays the time in seconds before replaying the announcement.
To Next Page
Loading...
Need help?
General