COPYRIGHT
©
2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
ii
INTRODUCTION
2 Outline of the Manual
This Service Manual contains basic facts and figures needed to service the machine, Paper
Deck-J1/K1, Buffer Pass Unit-B1, conducted to ensure a high level of performance and ex-
pected functions.
The following accessories come with separate service manuals or service informations;
refer to them for details:
1. RDF-E3
2. Stapler Sorter-F2
3. Film Projector-E1
4. Editor-F1
5. ED Board-C1
6. Interface Board-E1
7. Preview Monitor Board
* Refer to CLC1000 series service manual.
This Service Manual is organized as follows;
<Main body & Accessory>
Chapter 1 General Description: Features, specifications, how to operate
Chapter 2 New Functions: Principle operations of each unit;
timing of operations; how to disassemble and assemble
(special information from CLC1000 series only)
If necessary, refer CLC1000 series service manual.
Chapter 3 Installation: Requirements on the site of installation, installation pro-
cedure
Chapter 4 Maintenance And Inspection:Periodically replaced parts table, consumables and
durables table, scheduled servicing chart, scheduled ser-
vicing table
Chapter 5 Troubleshooting: Basic procedure for image adjustment, standards/adjust-
ments, troubleshooting image faults, troubleshooting mal-
functions
Appendix: General timing chart, general circuit diagrams
<Service Mode>
<Error Codes>
To Next Page
Loading...
