Canon E1 - Heaters; Removing the Air Heater Unit (AHT101;201;301)

Heaters
Removing the Air Heater Unit (AHT101/201/301)
■ Preparation
1. Release the lock to open the target Deck.“Releasing the Deck” on page 77
2. Remove the Right Cover of the target Deck.“Removing the Deck Right Upper Cover” on page 83, “Removing the
Deck Right Middle Cover” on page 82, “Removing the Deck Right Lower Cover” on page 83
NOTE:
When installing the Secondary Multi-drawer Paper Deck, the Stack Bypass or the POD Deck Lite C/XL, remove the Rear Cover
of the target Deck.
3. Remove the Deck Unit.“Removing the Deck Unit” on page 88
4. Remove the Shaft Plate Unit.“Removing the Deck Swing Motor (M102/202/302)” on page 111
■ Procedure
1. Remove the Connector Cover [1].
• 1 Claw [2]
• 2 Bosses [3]
[1]
[2]
[3]
[3]
1x
CAUTION:
When installing the Connector Cover, check that the Cable [1] is not in the hole [2] of the cable guide.
[2]
[1]
4. Parts Replacement and Cleaning
147