Canon E1 - Removing the through Path Cooling Fan 2 (FAN402)

CAUTION:
When installing the Through Path Cooling Fan, align the direction of the arrow [B] on the fan with the arrow (engraved mark)
[A] of the plate.
[A]
[B]
Removing the Through Path Cooling Fan 2 (FAN402)
■ Preparation
1. Remove the Right Connection Unit. “Removing the Right Connection Unit” on page 91
2. Remove the Deck Rear Middle Cover.“Removing the Deck Rear Middle Cover” on page 79
3. Remove the Through Path Unit. “Removing the Through Path Unit” on page 93
4. Remove the Through Path Outlet Unit. “Removing the Through Path Outlet Unit” on page 98
■ Procedure
1. Remove the Fixing Pin [1] and the Guide Plate [2].
• 3 Screws [3]
• 1 Hook [4]
3x
[2]
[1]
[3]
[3]
[3]
[4]
4. Parts Replacement and Cleaning
130