Canon E1 - Solenoids; Removing the Deck Open;Close Solenoid (SOL102;202;302)

Solenoids
Removing the Deck Open/Close Solenoid (SOL102/202/302)
■ Preparation
1. Remove the Rear Cover of the target Deck.“Removing the Deck Rear Upper Cover” on page 79, “Removing the Deck
Rear Middle Cover” on page 79, “Removing the Deck Rear Lower Cover” on page 79
■ Procedure
NOTE:
The removal procedure of the Deck Open/Close Solenoid from the Upper Deck is described below. The procedure of the Middle
and Lower Decks is the same.
1. Check the scale [1] of the Deck Open/Close Solenoid and take note of the installation position.
[1]
4. Parts Replacement and Cleaning
119