Canon E1 - Actions When Replacing the Deck Size Detection PCB (PCB101;201;301)

If there is the output of the "P-PRINT"
1. Based on the output setting values (P-PRINT), enter the adjustment values and setting values in the service mode. However,
in this case, the counter cannot enter.
If there is not the output of the "P-PRINT"
1. Enter the adjustment values and setting values written to the service label in the service mode.
2. Enter the Serial Number of Multi-drawer Paper Deck. (for imagePRESS V1000 series only)
COPIER> OPTION> SERIAL> PDECK1 (M Deck)
COPIER> OPTION> SERIAL> PDECK2 (Sec M Deck)
Actions when Replacing the Deck Size Detection PCB
(PCB101/201/301)
■ Handling after Parts Replacement
1. Turn ON the main power switch of the host machine.
2. To register the width of A4 paper.
1. Set the A4 paper in the deck to adjust and align it with the side guide plate.
2. Execute the following item on the service mode.
COPIER> FUNCTION> CST> MDK1-A4/MDK4-A4 : Upper (M Deck/Sec M Deck)
COPIER> FUNCTION> CST> MDK2-A4/MDK5-A4 : Middle (M Deck/Sec M Deck)
COPIER> FUNCTION> CST> MDK3-A4/MDK6-A4 : Lower (M Deck/Sec M Deck)
3. Select the item, and then press OK key.
4. After automatic adjustment, the value is stored in the following item.
COPIER> ADJUST> CST-ADJ >MDK1-A4/MDK4-A4 : Upper (M Deck/Sec M Deck)
COPIER> ADJUST> CST-ADJ> MDK2-A4/MDK5-A4 : Middle (M Deck/Sec M Deck)
COPIER> ADJUST >CST-ADJ> MDK3-A4/MDK6-A4 : Lower (M Deck/Sec M Deck)
3. To register the width of A5R paper.
1. Set the A5R paper in the deck to adjust and align it with the side guide plate.
2. Execute the following item on the service mode.
COPIER> FUNCTION> CST> MDK1-A5R/MDK4-A5R : Upper (M Deck/Sec M Deck)
COPIER> FUNCTION> CST> MDK2-A5R/MDK5-A5R : Middle (M Deck/Sec M Deck)
COPIER> FUNCTION> CST> MDK3-A5R/MDK6-A5R : Lower (M Deck/Sec M Deck)
3. Select the item, and then press OK key.
4. After automatic adjustment, the value is stored in the following item.
COPIER> ADJUST> CST-ADJ> MDK1-A5R/MDK4-A5R : Upper (M Deck/Sec M Deck)
COPIER> ADJUST> CST-ADJ> MDK2-A5R/MDK5-A5R : Middle (M Deck/Sec M Deck)
COPIER> ADJUST> CST-ADJ> MDK3-A5R/MDK6-A5R : Lower (M Deck/Sec M Deck)
5. Adjustment
175