Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Set./Adj. Menu is displayed.
3
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4
Press ▲ or ▼ to select AppleTalk, and then press the OK button.
5
Press ▲ or ▼ to select On, and then press the OK button.
6
Press the Menu button.
If any of the settings is changed, a confirmation message
is displayed. In this case, press the OK button.
Important
• Be sure to complete step 6. This will activate the values you have entered.
Note
• By using RemoteUI, you can also specify the object name used for AppleTalk, as well as the printer zone name.
For details on RemoteUI, see "Using RemoteUI." →P.475
Configuring the Destination (Mac OS X)
Important
• AppleTalk is supported in Mac OS X 10.2.8–10.4.
Note
• The following procedures are based on Mac OS X 10.4. The method of configuring the destination varies depending on
the version of Mac OS X.
• The imagePROGRAF printer driver is not compatible with AppleTalk.
1
In System Preferences, click Network to display the Network window.
iPF760
Configuring the Destination for AppleTalk Networks
User's Guide
Network Setting Mac OS X Settings
495
To Next Page