Canon iPF760 - Sheet Printing Is Selected; Regular Printing Is Selected, but a Roll Is Loaded; Paper Jam; Push the Release Lever Back

Cause Corrective Action
The roll is empty.
2. Load the new roll.
(See "Attaching the Roll Holder to Rolls.") →P.397
(See "Loading Rolls in the Printer.") →P.399
3. If no barcode was printed on the roll, specify the type of paper.
(See "Changing the Type of Paper.") →P.402
4. When you have selected ManageRemainRoll > On in the control panel menu and a barcode is not printed on
the roll, also specify the paper length.
(See "Specifying the Paper Length.") →P.403
5. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK
button.
Printing will resume, starting from the page on which the error occurred.
If no message appears, printing will continue from the next page.
There is remaining
roll paper, but be-
cause it could not be
advanced, it could
not be detected.
The unused portion of the roll is heavy, and this is placing a burden on the printer. It may be helpful to change the
printing mode, which will change the paper feed timing.
Choose a higher level of Print Quality in the Advanced Settings of the printer driver.
(See "Giving Priority to Particular Graphic Elements and Colors for Printing.")
→P.56
Sheet printing is selected.
Sheet printing is selected.
Cause Corrective Action
You have attempted to print a test print sheet or other
printer status information on a sheet, but no sheet is loa-
ded.
Press ▲ or ▼ to select Load Cut Sheet, and then press the OK button. Load
the sheet, and then print.
(See "Loading and Printing on Sheets.") →P.21
To print on rolls, follow these steps.
1. Press ▲ or ▼ to select Stop Printing, and then press the OK button to
stop printing.
2. Load a roll and try printing again.
(See "Loading and Printing on Rolls.")
→P.19
Regular printing is selected, but a roll is loaded.
Regular printing is selected, but a roll is loaded.
Cause Corrective Action
A print job for printing on
sheets was sent when a
roll is loaded.
1. Press ▲ or ▼ to select Remove Roll Paper, and then press the OK button to stop printing.
2. After removing the roll, load and print on a sheet of the type and size of paper you have specified in the
printer driver.
(See "Removing the Roll from the Printer.")
→P.404
(See "Loading and Printing on Sheets.") →P.21
Paper jam
Paper jam
"Push the release lever back."
Cause Corrective Action
A paper jam occur-
red in the printer
during printing.
1. Push the Release Lever back and remove the jammed paper.
(See "Clearing Jammed Roll Paper.") →P.552
(See "Clearing a Jammed Sheet.") →P.554
2. Load the paper.
3. Pull the Release Lever forward.
4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK
button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.")
→P.399
(See "Loading Sheets in the Printer.") →P.417
Sheet printing is selected. iPF760
User's Guide
Error Message Messages regarding paper
584