CAPINTEC, INC. CRC
®
-25R
Epson LX-300+II Menu Set-Up
If an Epson LX-300+II printer was ordered with the CRC
®
-25R system, the printer
should be set-up to function properly.
Should you experience printer difficulties, such as not printing, improper print spacing,
printing the wrong characters, etc., make sure that the printer Setup is exactly as
shown in Figure 5-15 Epson LX-300+II Printer Current Settings. If any differences
are found, they must be corrected.
Follow the steps below to enter Default Setting mode. If single sheets are used, a
new sheet of paper will need to be loaded each time the printer ejects a printed page.
The buttons referred to are all located on the front panel of the printer.
1. Make sure that the paper is properly loaded and the printer is off.
2. Hold down the TEAR OFF (FONT) button and then turn on the printer.
The printer enters Default Setting mode and prints instructions (as shown in
Figure 5-14 Epson LX-300+II Printer Language Selection Instructions) for
selecting the language. The current language is indicated by which control
panel lights are on. (For English, only the Pause light is on.)
3. If a different language is desired, press the LF/FF button until the lights show
the preferred language.
4. Press the TEAR OFF (FONT) button to print a list of all the current settings as
shown in Figure 5-15 Epson LX-300+II Printer Current Settings.
5 - 10 SYSTEM INITIALIZATION March 15
To Next Page
Loading...
Need help?
General