EasyManuals Logo

Chery A1 2009 User Manual

Chery A1 2009
1080 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
Electronic Engine Control Input & Output Device Failure Modes
NUMBER ITEM FAILURE MODE CORRECTION
1 CKP
• Engine is hard to start.
• The engine RPM will be limited after the engine starts.
• The highest RPM is less than 3800.
• Excessive exhaust emissions.
• No ignition signal to the ECM.
• The tachometer does not work.
• Rough engine operation.
Replace
2 CMP
• The fuel injector ON time may vary from 720 degrees to 360
degrees.
• The sensor output is not correct, the MIL light will turn on after
the engine starts.
• Engine is hard to start.
• The highest RPM is less than 4000.
Replace
3 APPS
• The MIL light will turn on.
• Poor acceleration.
• The engine RPM will be limited after the engine starts.
Replace
4 ECT
• Engine hard to start when cold.
• Engine hard to start when hot.
• Poor driving capability.
• If the sensor circuit is shorted to power, the engine will run
under the default values.
• The temperature gauge indicates too high.
• The temperature gauge indicates too low.
• The cooling fan operates continuously on high speed.
• The high temperature warning lamp will flash when the IP
indicates low temperature.
Replace
5 MAF
• The cooling fan will operate for approximately 60 seconds on
high speed after the ignition switch is turned off.
• Poor acceleration.
• Poor driving capability.
Replace
6 O
2
Sensor
• Poor fuel economy.
• Excessive exhaust emissions.
• Sluggish acceleration.
• Poor driving capability.
Replace
7 Knock Sensor
• The engine produces an engine knock.
• Overheated engine.
• Excessive exhaust emissions.
• Poor fuel economy.
• Lack of engine power.
• Internal engine damage.
Replace
8 ECM
• Unstable engine idle.
• Poor acceleration.
• Unable to start.
• High engine idle.
• The engine exhaust exceeds emission standards.
• Engine is hard to start.
• Air conditioner does not operate.
• Fuel injector control failure.
• Engine stalls out.
Replace
9 Ignition Coil
• Unstable idle.
• Lack of engine power.
• Poor fuel economy.
• Excessive exhaust emissions.
• Weak spark.
Replace
GENERAL INFORMATION
03–4
Chery Automobile Co., Ltd.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chery A1 2009 and is the answer not in the manual?

Chery A1 2009 Specifications

General IconGeneral
BrandChery
ModelA1 2009
CategoryAutomobile
LanguageEnglish

Related product manuals