Chery A1 2009 - Rear Crankshaft Oil Seal; Removal & Installation

4. Remove the crankshaft timing belt pulley bolt (2)
from the crankshaft.
(Tighten: Crankshaft timing belt pulley bolt to 130 ±
10 N·m and an additional 65 ± 5°)
5. Remove the key-way from the crankshaft.
6. Use an appropriate tool and remove the front
crankshaft oil seal (1).
CAUTION:
Be careful not to damage the front cover seal
surface while removing the seal.
7. Installation is in the reverse order of removal.
Installation Notes:
• Use the front crankshaft seal installer CH-20007 (1), to install the new seal.
• Lubricate the new front seal with engine oil prior to
assembly.
Rear Crankshaft Oil Seal
Removal & Installation
NOTE :
The following special tools are required to perform the repair procedure:
• CH-20005 - Rear Crankshaft Oil Seal Installer
• CH-20006 - Rear Crankshaft Oil Seal Guide
• CH-20043 - Flywheel Fixture
1. Remove the transaxle assembly (See Transaxle Assembly Removal & Installation in Section 08 Transaxle).
2. Using special tool CH-20043 (1), hold the flywheel.
ON-VEHICLE SERVICE
LTSM020199
LTSM020216
PZSM020026
02
02–29
Chery Automobile Co., Ltd.