Removal & Installation
NOTE :
The ECM is located on the driver side lower shroud of the instrument panel.
1. Disconnect the negative battery cable.
2. Remove the ECM mounting bolts (1).
(Tighten: ECM mounting bolts to 10 N·m)
3. Disconnect the ECM electrical connector.
4. Remove the ECM.
5. Installation is in the reverse order of removal.
Installation Notes:
NOTE :
The Immobilizer control module must be matched to the new ECM before the engine will start.
Matching Immobilizer Control Module to new Engine Control Module (ECM)
Perform the following to match the Immobilizer control module to the ECM:
− With the X-431 scan tool, choose A1 series.
− Choose 9immobilize9.
− Choose 9input code9.
− Input the safety code.
− Click the small keyboard.
− Click 9OK9.
− Choose 9Immobilizer adapt9.
− Choose 9read Immobilizer to ECM9 immediately.
− Click 9OK9.
ON-VEHICLE SERVICE
PZSM030021
03
03–177
Chery Automobile Co., Ltd.
To Next Page
Loading...
