ON-VEHICLE SERVICE
Exhaust Pipe Assembly
Removal & Installation
WARNING!
The normal operating temperature of the exhaust system is very high. Therefore, never work around, or attempt
to service any part of the exhaust system until it has cooled. Special care should be taken when working near
the catalytic converter. The temperature of the converter rises to a high level after a short period of engine oper-
ation.
1. Remove the heat shield retaining bolt (1).
2. Remove the exhaust manifold (See Exhaust Manifold Removal & Installation in Section 02 Engine).
3. Remove the catalytic converter to exhaust manifold
connecting bolts (1).
4. Remove the oxygen sensor (2).
5. Raise and support the vehicle.
6. Remove all the support isolators and connecting bolts.
PZSM070004
PZSM070002
07
07–5
Chery Automobile Co., Ltd.
To Next Page
