4. Remove the connecting rod bearings.
CAUTION: When removing the connecting rod side bearings, note the installation position. Keep them in
the correct order.
Inspection
• Check the radial clearance of the connecting rod bearings.
CONNECTING ROD RADIAL CLEARANCE
Radial Clearance 0.023 - 0.058 mm
Assembly
NOTE :
The rod bolts should not be reused.
1. Before installing the NEW rod bolts, the threads and under the bolt head should be oiled with clean engine oil.
2. Install each bolt finger tight, then alternately tighten each bolt to assemble the cap properly.
3. Tighten the connecting rod bolts using the two step
torque-turn method:
• 1st Step: Tighten bolts to 25 ± 3 N·m
• 2nd Step: Tighten the connecting rod bolts an
additional 90 ± 5°
ENGINE UNIT REPAIR
BESM020045
LTSM020208
02–62
Chery Automobile Co., Ltd.
To Next Page
Loading...
