Spark Plug
Removal & Installation
1. Disconnect the negative battery cable.
2. Twist the spark plug wire (1) from spark plug then
pull the spark plug wire straight up away from the
engine.
3. Remove the spark plug.
(Tighten: Spark plug to 30 N·m)
4. Inspect the spark plug condition.
5. Installation is in the reverse order of removal.
Installation Notes:
• Verify the proper spark plug gap before installing
spark plugs.
− Spark Plug Gap (A): 0.7-1.0 mm
ON-VEHICLE SERVICE
PZSM030016
BESM030011
03–206
Chery Automobile Co., Ltd.
To Next Page
Loading...
