3. Remove the four thermostat housing mounting
bolts (1).
(Tighten: Thermostat housing mounting bolts to
8 ± 3 N·m)
4. Remove the thermostat and gasket.
5. Installation is in the reverse order of removal.
Installation Notes:
• Replace the thermostat gasket.
• Verify the cooling system is filled to proper specifications.
• Start the engine and verify there are no leaks in the cooling system.
Thermostat Inspection
1. Inspect the sealing surface of the thermostat (the
seat should be tight at room temperature).
2. Inspect the opening temperature and maximum
stroke of the thermostat.
• Opening temperature of the thermostat is 87 ±
2°C
• Maximum stroke of the thermostat is 8 mm
• Full opening temperature of the thermostat is
104°C
3. Verify the thermostat closes 5°C lower than the
opening temperature.
4. If the thermostat fails any of the inspection steps,
replace the thermostat.
Coolant Pump
Removal & Installation
WARNING!
Always allow the engine to cool before opening the cooling system. Do not loosen the coolant pressure relief
cap when the engine is operating or the cooling system is hot. The cooling system is under pressure; steam and
hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may
result in serious personal injury.
1. Drain the cooling system (See Cooling System Draining Procedure in Section 06 Cooling System).
2. Remove the timing belt (See Timing Belt Removal & Installation in Section 02 Engine).
ON-VEHICLE SERVICE
PZSM060002
LTSM060014
06–10
Chery Automobile Co., Ltd.
To Next Page
Loading...
Need help?
General
