GENERAL INFORMATION
Description
The steering gear used is the rack-and-pinion type with power assist. It is mounted on the front suspension sub-
frame. The outer ends of the outer tie rods attach to the front knuckles.
NOTE :
The power steering gear should not be serviced or adjusted. If a malfunction or oil leak occurs with the steering gear,
the complete steering gear needs to be replaced.
Operation
The steering wheel turns the pinion. The rack is a long flat bar with teeth on one side. The rack teeth mesh with the
teeth on the pinion. Rotation of the pinion moves the rack from left to right and right to left. The tie rod then causes
the wheels to turn to the left or right.
Specifications
Torque Specifications
DESCRIPTION TORQUE (N·m)
Inlet / Outlet Pipe Nut 25 ± 5
Intermediate Shaft Bolt 25 ± 3
Steering Gear to Sub-Frame Bolts 100 ± 10
Sub-Frame Assembly Bolts 180 ± 15
Tie Rod End Nut 40 ± 5
Tie Rod Jam Nut 35 ± 3
Wheel Mounting Nuts 110
Special Tools
Ball Joint Separator
CH-10002
11
11–21
Chery Automobile Co., Ltd.
To Next Page
Loading...
Need help?
General
