7. Remove the four spiral cable retaining bolts (1).
(Tighten: Spiral cable retaining bolts to 7 ± 2 N·m)
8. Disconnect the multi-function switch & wiper and washer switch assembly electrical connector.
9. Remove the two multi-function switch & wiper and
washer switch assembly retaining bolts (1).
(Tighten: Multi-function switch & wiper and washer
switch assembly bolts to 7 ± 2 N·m)
10. Remove the multi-function switch & wiper and washer switch assembly.
11. Disconnect the ignition switch electrical connector.
ON-VEHICLE SERVICE
PZSM110032
PZSM110001
11–16
Chery Automobile Co., Ltd.
To Next Page
Loading...
