3. Loosen the tie rod jam nut (1).
(Tighten: Tie rod jam nut to 35 ± 3 N·m)
4. Remove the nut (1) attaching the outer tie rod end
to the steering knuckle.
(Tighten: Outer tie rod end nut to 40 ± 5 N·m)
5. Using special tool CH-10002, separate the outer tie
rod end from the steering knuckle.
6. Remove the outer tie rod end from the steering rack.
NOTE :
When removing the outer tie rod end, count the number of revolutions when removing. This will aid in installation,
getting the toe setting close to where it needs to be when setting the final toe-in wheel alignment.
7. Installation is in the reverse order of removal.
Installation Notes:
• After installing the new tie rod end, perform a front end alignment procedure to reset the toe-in (See Front
Wheel Alignment in Section 10 Suspension).
ON-VEHICLE SERVICE
VISM100021
LTSM110034
LTSM110027
11
11–35
Chery Automobile Co., Ltd.
To Next Page
Loading...
Need help?
General
