4.
PERFORM THE RKE TRANSMITTER MATCH WITH THE X-431
• Replace the RKE transmitter.
• Connect the X-431 scan tool to the Data Link Connector (DLC), press the POWER key to start the X-431 (use
the most current software available).
• Turn ignition switch on.
− Enter the Diagnostic Program.
− Select Chery main program.
− Select diagnostic version.
− Enter download program.
− Select A1 series, and then select ISU.
− Select 9Remoter Match9.
• Remove the key from the ignition switch.
• Press the lock button on the RKE transmitter for less than 2 seconds.
• Try to operate the RKE transmitter.
Does the RKE transmitter operate properly?
Yes
>>
Then click OK to rematch the other RKE transmitter according to the display.
Erase all codes before returning the vehicle to the customer.
The concern was caused by the RKE transmitter.
No
>>
Replace the BCM (See BCM Removal & Installation in Section 15 Body & Accessories).
Match the RKE transmitter to the BCM with the X-431 scan tool. For detailed instructions, go to step
4.
ON-VEHICLE SERVICE
LTSMD150020T
15
15–151
Chery Automobile Co., Ltd.
To Next Page
Loading...
Need help?
General
