Cisco ASR 9000 Series Reference Guide

The following sample output is from the show l2vpn forwarding command:
RP/0/RSP0/CPU0:router# show l2vpn forwarding location 0/2/cpu0
ID Segment 1 Segment 2
-----------------------------------
1 Gi0/2/0/0 1 1.1.1.1 9)
The following sample output shows the MAC information in the layer2_fib manager summary:
RP/0/RSP0/CPU0:router# show l2vpn forwarding summary location 0/3/CPU0
Major version num:1, minor version num:0
Shared memory timestamp:0x66ff58e894
Number of forwarding xconnect entries:2
Up:1 Down:0
AC-PW:0 AC-AC:0 AC-BP:1 PW-BP:1
Number of xconnects down due to:
AIB:0 L2VPN:0 L3FIB:0
Number of nexthops:1
Number of static macs: 5
Number of locally learned macs: 5
Number of remotely learned macs: 0
Number of total macs: 10
This example shows the sample output of a configured flow label:
RP/0/RSP0/CPU0:router# show l2vpn for 0/0/cPU0
Local interface: GigabitEthernet0/0/1/1, Xconnect id: 0x1000002, Status: up
Segment 1
AC, GigabitEthernet0/0/1/1, Ethernet port mode, status: Bound
Segment 2
MPLS, Destination address: 3.3.3.3, pw-id: 2, status: Bound, Active
Pseudowire label: 16004 Control word disabled
Backup PW
MPLS, Destination address: 2.2.2.2, pw-id: 6, status: Bound
Pseudowire label: 16000
Flow label enabled
Xconnect id: 0xff000014, Status: down
Segment 1
MPLS, Destination address: 2.2.2.2, pw-id: 1, status: Not bound
Pseudowire label: UNKNOWN Control word disabled
Flow label enabled
Segment 2
Bridge id: 0, Split horizon group id: 0
Storm control: disabled
MAC learning: enabled
MAC port down flush: enabled
Flooding:
Broadcast & Multicast: enabled
Unknown unicast: enabled
MAC aging time: 300 s, Type: inactivity
MAC limit: 4000, Action: none, Notification: syslog
MAC limit reached: no
Security: disabled
DHCPv4 snooping: profile not known on this node, disabled
IGMP snooping profile: profile not known on this node
Router guard disabled
This example shows sample output for the show l2vpn forwarding location command:
RP/0/RSP0/CPU0:router# show l2vpn forwarding location 0/1/CPU0
LC/0/1/CPU0:JSegment 1 Segment 2 State
------------------------------------ ------------------------------------ ---
PBB Edge Bridge id 0, SHG id 0 UP
Gi0/1/0/1.1(Eth VLAN) Bridge id 0, SHG id 0 UP
Gi0/1/0/1.2(Eth VLAN) Bridge id 0, SHG id 0 UP
mpls 1.2.3.4,22 Bridge id 1, SHG id 0 DN
PBB Core Bridge id 2, SHG id 0 UP
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
177
Point to Point Layer 2 Services Commands
show l2vpn forwarding

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model