Cisco ASR 9000 Series - Page 193

bytes: received 0 (multicast 0, broadcast 0, unknown unicast 0, unicast 0), sent 0
MAC move: 0
packets dropped: PLU 0, tail 0
bytes dropped: PLU 0, tail 0
Segment 2
Bridge id: 19, Split horizon group id: 0
Storm control: disabled
MAC learning: enabled
MAC port down flush: enabled
Flooding:
Broadcast & Multicast: enabled
Unknown unicast: enabled
MAC aging time: 300 s, Type: inactivity
MAC limit: 4000, Action: none, Notification: syslog
MAC limit reached: no
MAC Secure: disabled, Logging: disabled, Accept-Shutdown: enabled
DHCPv4 snooping: profile not known on this node, disabled
Dynamic ARP Inspection: disabled, Logging: disabled
IP Source Guard: disabled, Logging: disabled
IGMP snooping profile: profile not known on this node
MLD snooping profile: profile not known on this node
Router guard disabled
P2MP PW: disabled
The following sample output is from the show l2vpn forwarding command:
RP/0/RSP0/CPU0:router# show l2vpn for location 0/0/CPU0
Fri May 18 13:56:35.957 EDT
Segment 1 Segment 2 State
------------------------------------ ------------------------------------ ------
Gi0/0/0/4.2(Eth VLAN) l2tpv3 UP
1111:2222::cdef
Gi0/0/0/4.3(Eth VLAN) mpls 1.2.3.4 DN
The following sample output is from the show l2vpn forwarding neighbor ipv6 command:
RP/0/RSP0/CPU0:router# show l2vpn forwarding neighbor ipv6 1111:2222::cdef detail loc
0/0/cpu0
Fri May 18 13:58:14.720 EDT
Local interface: GigabitEthernet0/0/0/4.2, Xconnect id: 0x2, Status: up
Segment 1
AC, GigabitEthernet0/0/0/4.2, Ethernet VLAN mode, status: Bound
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
Segment 2
L2TPv3-IPV6, Destination address: 1111:2222::cdef, status: Bound
Source address: 1111:2222::abcd
Local session:
Session ID: -1
Cookie: size 0 bytes
Remote session:
Session ID: -1
Cookie: size 0 bytes
Control word disabled
Sequencing not set
TOS 40 (reflect disabled), TTL 255, DF bit not set
Path MTU: disabled
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
packets dropped: out of sequence 0, other 0
This example shows sample output for the show l2vpn forwarding detail location command with P2MP
PW enabled on the PW BP for IOS-XR 5.3.1 and earlier releases.
RP/0/RSP0/CPU0:router# show l2vpn forwarding detail location
Xconnect id: 0xfffc0003, Status: up
Segment 1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
179
Point to Point Layer 2 Services Commands
show l2vpn forwarding