Cisco ASR 9000 Series - Page 225

Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
PW: neighbor 130.130.130.130, PW ID 1234, state is down ( provisioned )
PW class not set
Encapsulation MPLS, protocol LDP
PW type Ethernet VLAN, control word disabled, interworking none
Sequencing not set
Internal label: 16008
VLAN id imposed: 101
MPLS Local Remote
------------ ------------------------------ -----------------------------
Label 16001 unknown
Group ID 0x2000600 0x0
Interface PW-Ether1 unknown
MTU 1500 unknown
Control word disabled unknown
PW type Ethernet VLAN unknown
VCCV CV type 0x2 0x0
(none)
(LSP ping verification)
VCCV CC type 0x6 0x0
(none)
(router alert label)
(TTL expiry)
------------ ------------------------------ -----------------------------
MIB cpwVcIndex: 2
Create time: 19/02/2010 23:13:01 (1w2d ago)
Last time status changed: 19/02/2010 23:13:16 (1w2d ago)
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
This example shows the sample output of a configured flow label:
RP/0/RSP0/CPU0:router# show l2vpn xconnect detail
Group g1, XC p1, state is up; Interworking none
AC: GigabitEthernet0/0/1/1, state is up
Type Ethernet
MTU 1500; XC ID 0x1000002; interworking none
Statistics:
packets: received 24688, sent 24686
bytes: received 1488097, sent 1487926
PW: neighbor 3.3.3.3, PW ID 2, state is up ( established )
PW class class1, XC ID 0x1000002
Encapsulation MPLS, protocol LDP
PW type Ethernet, control word disabled, interworking none
PW backup disable delay 0 sec
Sequencing not set
Flow label flags configured (Rx=1,Tx=1), negotiated (Rx=0,Tx=1)
This table describes the significant fields shown in the display.
Table 6: show l2vpn xconnect Command Field Descriptions
DescriptionField
Displays a list of all configured cross-connect groups.XConnect Group
Displays the cross-connect group number.Group
Displays the cross-connect group name.Name
Displays the cross-connect group description. If no
description is configured, the interface type is
displayed.
Description
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
211
Point to Point Layer 2 Services Commands
show l2vpn xconnect