Cisco ASR 9000 Series - Page 226

DescriptionField
State of the cross-connect group: up (UP) or down
(DN).
ST
This example shows the output of the show l2vpn xconnect command with IPv6 addresses listed:
RP/0/RSP0/CPU0:router# show l2vpn xconnect
Fri May 18 10:25:48.279 EDT
Legend: ST = State, UP = Up, DN = Down, AD = Admin Down, UR = Unresolved,
SB = Standby, SR = Standby Ready, (PP) = Partially Programmed
XConnect Segment 1 Segment 2
Group Name ST Description ST Description ST
------------------ ----------------------------- ---------------------------------------
g1 xc1 DN Gi0/0/0/4.3 UP 1.2.3.4 1 DN
----------------------------------------------------------------------------------------
g1 xc2 UR Gi0/0/0/4.1 DN 1 UR
aaaa:bbbb::cdef
----------------------------------------------------------------------------------------
g1 xc3 UP Gi0/0/0/4.2 UP 1 UP
1111:2222::cdef
----------------------------------------------------------------------------------------
g1 xc4 UR Gi0/0/0/4.4 DN 1 UR
1111:3333::4444
----------------------------------------------------------------------------------------
This example shows the output of the show l2vpn xconnect interface command:
RP/0/RSP0/CPU0:router# show l2vpn xconnect interface Gi0/0/0/4.4 detail
Fri May 18 10:34:28.263 EDT
Group g1, XC xc4, state is unresolved; Interworking none
Not provisioned reason(s):
IPv6 not supported for this service
AC: GigabitEthernet0/0/0/4.4, state is down (Segment-down)
Type VLAN; Num Ranges: 1
VLAN ranges: [4, 4]
MTU 1500; XC ID 0x4; interworking none
PW: neighbor 1111:3333::4444, PW ID 1, state is unresolved
This example shows the output of the show running-config l2vpn xconnect group command with IPv6
neighbor information:
RP/0/RSP0/CPU0:router# show running-config l2vpn xconnect group g1 p2p xc4
Fri May 18 10:35:51.734 EDT
l2vpn
xconnect group g1
p2p xc4
interface GigabitEthernet0/0/0/4.4
neighbor ipv6 1111:3333::4444 pw-id 1
!
This example shows the output of the show l2vpn xconnect neighbor ipv4 command:
RP/0/RSP0/CPU0:router# show l2vpn xconnect neighbor ipv4 1.2.3.4
Fri May 18 10:28:22.289 EDT
Legend: ST = State, UP = Up, DN = Down, AD = Admin Down, UR = Unresolved,
SB = Standby, SR = Standby Ready, (PP) = Partially Programmed
XConnect Segment 1 Segment 2
Group Name ST Description ST Description ST
------------------ ----------------------------- ---------------------------------------
g1 xc1 DN Gi0/0/0/4.3 UP 1.2.3.4 1 DN
----------------------------------------------------------------------------------------
This example shows the output of the show l2vpn xconnect neighbor ipv6 command:
RP/0/RSP0/CPU0:router# show l2vpn xconnect neighbor ipv6 1111:2222::cdef
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
212
Point to Point Layer 2 Services Commands
show l2vpn xconnect