The following sample output shows brief information about the bridges:
RP/0/RSP0/CPU0:router# show l2vpn bridge-domain brief
Bridge Group/Bridge-Domain Name ID State Num ACs/up Num PWs/up
-------------------------------- ----- ---------- -------------- ------------
bg1/bd1 0 up 1/1 0/0
bg1/bd2 1 up 0/0 0/0
bg1/bd3 2 up 0/0 0/0
This table describes the significant fields shown in the display.
Table 8: show l2vpn bridge-domain brief Command Field Descriptions
DescriptionField
Bridge domain group name followed by the bridge
domain name are displayed.
Bridge Group/Bridge-Domain Name
ID assigned to this bridge domain is displayed.ID
Current state of the bridge domain is displayed.State
Total number of attachment circuits that are up in this
bridge domain is displayed.
Num ACs/up
Total number of pseudowires that are up in this bridge
domain is displayed. The count includes both VFI
pseudowires and access pseudowires.
Num PWs/up
The following sample output shows detailed information for IOS-XR releases 5.3.1 and earlier releases.
RP/0/RSP0/CPU0:router# show l2vpn bridge-domain detail
Bridge group: 210, bridge-domain: 210, id: 2, state: up, ShgId: 0, MSTi: 0
MAC learning: enabled
MAC withdraw: disabled
Flooding:
Broadcast & Multicast: enabled
Unknown unicast: enabled
MAC aging time: 300 s, Type: inactivity
MAC limit: 4000, Action: none, Notification: syslog
MAC limit reached: no
Security: disabled
Split Horizon Group: none
DHCPv4 snooping: disabled
IGMP Snooping profile: none
Bridge MTU: 9000
Filter MAC addresses:
ACs: 1 (1 up), VFIs: 1, PWs: 1 (1 up)
List of ACs:
AC: GigabitEthernet0/1/0/7.210, state is up
Type VLAN; Num Ranges: 1
vlan ranges: [100, 100]
MTU 9008; XC ID 0x440007; interworking none; MSTi 0 (unprotected)
MAC learning: enabled
Flooding:
Broadcast & Multicast: enabled
Unknown unicast: enabled
MAC aging time: 300 s, Type: inactivity
MAC limit: 4000, Action: none, Notification: syslog
MAC limit reached: no
Security: disabled
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
323
Multipoint Layer 2 Services Commands
show l2vpn bridge-domain (VPLS)