Cisco Catalyst 3750-X Command Reference

2-983
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
vlan access-map
You can use the no vlan access-map name [number] command with a sequence number to delete a single
entry.
In global configuration mode, use the vlan filter interface configuration command to apply the map to
one or more VLANs.
For more information about VLAN map entries, see the software configuration guide for this release.
Examples This example shows how to create a VLAN map named vac1 and apply matching conditions and actions
to it. If no other entries already exist in the map, this will be entry 10.
Switch(config)# vlan access-map vac1
Switch(config-access-map)# match ip address acl1
Switch(config-access-map)# action forward
This example shows how to delete VLAN map vac1:
Switch(config)# no vlan access-map vac1
Related Commands Command Description
action Sets the action for the VLAN access map entry.
match (access-map configuration) Sets the VLAN map to match packets against one or more access
lists.
show vlan access-map Displays information about a particular VLAN access map or all
VLAN access maps.
vlan filter Applies the VLAN access map to one or more VLANs.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing