Cisco Catalyst 3750-X Command Reference

2-818
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show udld
show udld
Use the show udld user EXEC command to display UniDirectional Link Detection (UDLD)
administrative and operational status for all ports or the specified port.
show udld [interface-id]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines If you do not enter an interface-id, administrative and operational UDLD status for all interfaces appear.
Examples This is an example of output from the show udld interface-id command. For this display, UDLD is
enabled on both ends of the link, and UDLD detects that the link is bidirectional. Table 2-51 describes
the fields in this display.
Switch> show udld gigabitethernet2/0/1
Interface gi2/0/1
---
Port enable administrative configuration setting: Follows device default
Port enable operational state: Enabled
Current bidirectional state: Bidirectional
Current operational state: Advertisement - Single Neighbor detected
Message interval: 60
Time out interval: 5
Entry 1
Expiration time: 146
Device ID: 1
Current neighbor state: Bidirectional
Device name: Switch-A
Port ID: Gi2/0/1
Neighbor echo 1 device: Switch-B
Neighbor echo 1 port: Gi2/0/2
Message interval: 5
CDP Device name: Switch-A
interface-id (Optional) ID of the interface and port number. Valid interfaces include
physical ports and VLANs. The VLAN range is 1 to 4094.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing