Cisco Catalyst 3750-X

2-552
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
session
session
Use the session privileged EXEC command on the stack master to access a specific stack member.
session stack-member-number
Note This command is supported only on Catalyst 3750-X switches.
Syntax Description
Defaults No default is defined.
Command Modes Global configuration
Command History
Usage Guidelines When you access the stack member, its stack member number is appended to the system prompt.
Examples This example shows how to access stack member 6:
Switch(config)# session 6
Switch-6#
Related Commands
stack-member-number Specify the stack member number. The range is 1 to 9.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
reload Reloads the stack member and puts a configuration change into effect.
switch priority Changes the stack member priority value.
switch renumber Changes the stack member number.
show switch Displays information about the switch stack and its stack members.