Cisco Catalyst 3750-X Command Reference

B-101
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug sw-vlan notification
debug sw-vlan notification
Use the debug sw-vlan notification privileged EXEC command to enable debugging of the activation
and deactivation of Inter-Link Switch (ISL) VLAN IDs. Use the no form of this command to disable
debugging.
debug sw-vlan notification {accfwdchange | allowedvlancfgchange | fwdchange | linkchange |
modechange | pruningcfgchange | statechange}
no debug sw-vlan notification {accfwdchange | allowedvlancfgchange | fwdchange |
linkchange | modechange | pruningcfgchange | statechange}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug sw-vlan notification command is the same as the no debug sw-vlan notification
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
accfwdchange Display debug messages for VLAN manager notification of aggregated
access interface spanning-tree forward changes.
allowedvlancfgchange Display debug messages for VLAN manager notification of changes to the
allowed VLAN configuration.
fwdchange Display debug messages for VLAN manager notification of spanning-tree
forwarding changes.
linkchange Display debug messages for VLAN manager notification of interface
link-state changes.
modechange Display debug messages for VLAN manager notification of interface mode
changes.
pruningcfgchange Display debug messages for VLAN manager notification of changes to the
pruning configuration.
statechange Display debug messages for VLAN manager notification of interface state
changes.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing