2-51
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
authentication timer
authentication timer
Use the authentication timer interface configuration command to configure the timeout and
reauthentication parameters for an 802.1x-enabled port.
authentication timer {{[inactivity | reauthenticate]} {restart value}}
no authentication timer {{[inactivity | reauthenticate]} {restart value}}
Syntax Description
Defaults The inactivity and restart keywords are set to 60 seconds. The reauthenticate keyword is set to one
hour.
Command Modes Interface configuration
Command History
Usage Guidelines If a timeout value is not configured, an 802.1x session stays authorized indefinitely. No other host can
use the port, and the connected host cannot move to another port on the same switch.
Examples This example shows how to set the authentication inactivity timer to 60 seconds:
Switch(config-if)# authentication timer inactivity 60
This example shows how to set the reauthentication timer to 120 seconds:
Switch(config-if)# authentication timer restart 120
You can verify your settings by entering the show authentication privileged EXEC command.
Related Commands
inactivity Interval in seconds after which the client is unauthorized if there is no
activity.
reauthenticate Time in seconds after which an automatic re-authentication attempt starts.
restart Interval in seconds after which an attempt is made to authenticate an
unauthorized port.
value Enter a value between 1 and 65535 (in seconds).
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
authentication
control-direction
Configures the port mode as unidirectional or bidirectional.
authentication event Sets the action for specific authentication events.
To Next Page
Loading...
Need help?
General
