B-69
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform port-asic
debug platform port-asic
Use the debug platform port-asic privileged EXEC command to enable debugging of the port
application-specific integrated circuit (ASIC) driver. Use the no form of this command to disable
debugging.
debug platform port-asic {interrupt | periodic | read | stack | write}
no debug platform port-asic {interrupt | periodic | read | stack | write}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform port-asic command is the same as the no debug platform port-asic command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
interrupt Display port-ASIC interrupt-related function debug messages.
periodic Display port-ASIC periodic-function-call debug messages.
read Display port-ASIC read debug messages.
stack Display stacking-related function debug messages.
This keyword is supported only on Catalyst 3750-X switches.
write Display port-ASIC write debug messages.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General
