EasyManuals Logo

Cisco Catalyst 3750-X Command Reference

Cisco Catalyst 3750-X
1244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #339 background imageLoading...
Page #339 background image
2-307
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
ip sticky-arp (global configuration)
ip sticky-arp (global configuration)
Use the ip sticky-arp global configuration command to enable sticky Address Resolution Protocol
(ARP) on a switch virtual interface (SVI) that belongs to a private VLAN. Use the no form of this
command to disable sticky ARP.
ip sticky-arp
no ip sticky-arp
Syntax Description This command has no arguments or keywords.
Defaults Sticky ARP is enabled.
Command Modes Global configuration
Command History
Usage Guidelines Sticky ARP entries are those learned on private-VLAN SVIs. These entries do not age out.
The ip sticky-arp global configuration command is supported only on SVIs belonging to private
VLANs.
When you configure a private VLAN, sticky ARP is enabled on the switch (the default).
If you enter the ip sticky-arp interface configuration command, it does not take effect.
If you enter the no ip sticky-arp interface configuration command, you do not disable sticky ARP
on an interface.
Note We recommend that you use the show arp privileged EXEC command to display and verify
private-VLAN interface ARP entries.
If you disconnect the switch from a device and then connect it to another device with a different
MAC address but with the same IP address, the ARP entry is not created, and this message appears:
*Mar 2 00:26:06.967: %IP-3-STCKYARPOVR: Attempt to overwrite Sticky ARP entry:
20.6.2.1, hw: 0000.0602.0001 by hw: 0000.0503.0001
If a MAC address of a device changes, you must use the no arp ip-address global configuration
command to manually remove the private-VLAN interface ARP entries.
Use the arp ip-address hardware-address type global configuration command to add a
private-VLAN ARP entry.
Release Modification
12.2(53)SE2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals