Cisco Catalyst 3750-X Command Reference

C-12
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix C Catalyst 3750-X and 3560-X Show Platform Commands
show platform ip unicast
show platform ip unicast
Use the show platform ip unicast privileged EXEC command to display platform-dependent IP unicast
routing information.
show platform ip unicast {adjacency | cef-idb | counts | dhcp | failed {adjacency | arp [A.B.C.D]
| route} | loadbalance | mpaths | proxy | route | rpf {A.B.C.D {A.B.C.D} | stats interface-id}
standby | statistics | table | trace}
Note This command is not supported on switches running the LAN base feature set.
Syntax Description
Note Though visible in the command-line help strings, the proxy and table keywords are not supported.
adjacency Display the platform adjacency database.
cef-idb Display platform information corresponding to Cisco Express Forwarding
(CEF) interface descriptor block.
counts Display the current counts for the Layer 3 unicast databases.
dhcp Display the DHCP system dynamic addresses.
failed {adjacency |
arp [A.B.C.D] | route}
Display the hardware resource failures. The keywords have these meanings:
• adjacency—Display the adjacency entries that failed to be programmed
in hardware.
• arp—Display the Address Resolution Protocol (ARP) deletions because
of failure and because of retries.
• A.B.C.D—(Optional) Prefix of the ARP entries to display.
• route—Display the route entries that failed to be programmed in
hardware.
loadbalance Display the platform load-balance database.
mpaths Display the Layer 3 unicast routing multipath adjacency database.
proxy Display the platform proxy ARP database.
route Display the platform route database.
rpf {A.B.C.D
{A.B.C.D} | stats
interface-id}
Display the unicast reverse path forwarding (unicast RPF) platform
information. The keywords have these meanings:
• A.B.C.D {A.B.C.D}—Prefix and prefix mask of the RPF entries to
display.
• stats—Display the unicast RPF statistics for the specified interface.
standby Display the platform standby information.
statistics Display the Layer 3 unicast routing accumulated statistics.
table Display the platform IP version 4 (IPv4) information.
trace Display the platform event trace logs.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing