B-60
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform ip wccp
debug platform ip wccp
Use the debug platform ip wccp privileged EXEC command to enable debugging of Web Cache
Communication Protocol (WCCP). Use the no form of this command to disable debugging.
debug platform ip wccp {acl | event | odm | trace}
no debug platform ip wccp {acl | event | odm | trace}
Note This command is available only if your switch is running the IP services feature set.
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform ip wccp command is the same as the no debug platform ip wccp command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
acl Display WCCP access control lists (ACLs).
event Display WCCP event debug messages.
odm Display WCCP OD merge VMRs.
trace Trace WCCP execution.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are
enabled.
To Next Page
Loading...
Need help?
General
