Cisco Catalyst 3750-X Command Reference

2-998
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
vtp (interface configuration)
vtp (interface configuration)
Use the vtp interface configuration command to enable the VLAN Trunking Protocol (VTP) on a
per-port basis. Use the no form of this command to disable VTP on the interface.
vtp
no vtp
Note This command is supported only when the switch is running VTP version 3.
Syntax Description This command has no keywords or arguments.
Command Default This command has no default settings.
Command Modes Interface configuration.
Command History
Usage Guidelines Enter this command only interfaces that are switchport in trunk mode.
This command is supported only on switches configured for VTP version 3.
Examples This example shows how to enable VTP on an interface:
Switch(config-if)# vtp
This example shows how to disable VTP on an interface:
Switch(config-if)# no vtp
Related Commands
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
vtp (global
configuration)
Globally configures VTP domain-name, password, pruning, version, and
mode.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing