2-445
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
network-policy profile (global configuration)
network-policy profile (global configuration)
Use the network-policy profile global configuration command to create a network-policy profile and to
enter network-policy configuration mode. Use the no form of this command to delete the policy and to
return to global configuration mode.
network-policy profile profile number
no network-policy profile profile number
Syntax Description
Defaults No network-policy profiles are defined.
Command Modes Global configuration
Command History
Usage Guidelines Use the network-policy profile global configuration command to create a profile and to enter
network-policy profile configuration mode.
To return to the privileged EXEC mode from the network-policy profile configuration mode, enter the
exit command.
When you are in network-policy profile configuration mode, you can create the profile for voice and
voice-signalling by specifying the values for VLAN, class of service (CoS), differentiated services code
point (DSCP), and tagging mode.
These profile attributes are then contained in the Link Layer Discovery Protocol for Media Endpoint
Devices (LLDP-MED) network-policy time-length-value (TLV).
Examples This example shows how to create network-policy profile 60:
Switch(config)# network-policy profile 60
Switch(config-network-policy)#
Related Commands
profile number Specify the network-policy profile number. The range is 1 to
4294967295.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
network-policy Applies a network-policy to an interface.
network-policy profile
(network-policy configuration)
Configures the attributes of network-policy profiles.
show network-policy profile Displays the configured network-policy profiles.
To Next Page
Loading...
Need help?
General
