Cisco Catalyst 3750-X Command Reference

2-898
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
speed
speed
Use the speed interface configuration command on the switch stack or on a standalone switch to specify
the speed of a 10/100 Mb/s or 10/100/1000 Mb/s port. Use the no or default form of this command to
return the port to its default value.
speed {10 | 100 | 1000 | auto [10 | 100 | 1000] | nonegotiate}
no speed
Syntax Description
Defaults The default is auto.
Command Modes Interface configuration
Command History
Usage Guidelines You cannot configure speed on the 10-Gigabit Ethernet ports.
Except for the 1000BASE-T small form-factor pluggable (SFP) modules, you can configure the speed to
not negotiate (nonegotiate) when an SFP module port is connected to a device that does not support
autonegotiation.
If the speed is set to auto, the switch negotiates with the device at the other end of the link for the speed
setting and then forces the speed setting to the negotiated value. The duplex setting remains as
configured on each end of the link, which could result in a duplex setting mismatch.
If both ends of the line support autonegotiation, we highly recommend the default autonegotiation
settings. If one interface supports autonegotiation and the other end does not, do use the auto setting on
the supported side, but set the duplex and speed on the other side.
Caution Changing the interface speed and duplex mode configuration might shut down and re-enable the
interface during the reconfiguration.
10 Port runs at 10 Mb/s.
100 Port runs at 100 Mb/s.
1000 Port runs at 1000 Mb/s. This option is valid and visible only on 10/100/1000
Mb/s-ports.
auto Port automatically detects the speed it should run at based on the port at the other
end of the link. If you use the 10, 100, or 1000 keywords with the auto keyword, the
port only autonegotiates at the specified speeds.
nonegotiate Autonegotiation is disabled, and the port runs at 1000 Mb/s.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing