Cisco Catalyst 3750-X Command Reference

B-42
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform cli-redirection main
debug platform cli-redirection main
Use the debug platform cli-redirection main privileged EXEC command to enable debugging of the
main (important) command-line interface (CLI) redirection events. Use the no form of this command to
disable debugging.
debug platform cli-redirection main
no debug platform cli-redirection main
Note This command is supported only on Catalyst 3750-X switches.
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform cli-redirection main command is the same as the no debug platform
cli-redirection main command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing