EasyManuals Logo

Cisco Catalyst 3750-X Command Reference

Cisco Catalyst 3750-X
1244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #343 background imageLoading...
Page #343 background image
2-311
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
ip verify source
ip verify source
Use the ip verify source interface configuration command on the switch stack or on a standalone switch
to enable IP source guard on an interface. Use the no form of this command to disable IP source guard.
ip verify source {vlan dhcp-snooping | tracking} [port-security]
no ip verify source {vlan dhcp-snooping | tracking} [port-security]
Syntax Description
Defaults IP source guard is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines To enable IP source guard with source IP address filtering, use the ip verify source interface
configuration command.
To enable IP source guard with source IP and MAC address filtering, use the ip verify source
port-security interface configuration command.
To enable IP source guard with source IP and MAC address filtering, you must enable port security on
the interface.
Examples This example shows how to enable IP source guard on VLANs 10 through 20 on a per-port basis:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# ip dhcp snooping
Switch(config)# ip dhcp snooping vlan 10 20
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport trunk encapsulation dot1q
Switch(config-if)# switchport mode trunk
Switch(config-if)# switchport trunk native vlan 10
Switch(config-if)# switchport trunk allowed vlan 11-20
Switch(config-if)# no ip dhcp snooping trust
Switch(config-if)# ip verify source vlan dhcp-snooping
Switch(config)# end
Switch# show ip verify source interface fastethernet0/1
vlan dhcp-snooping Enable IP source guard on an untrusted Layer 2 DHCP snooping interfaces.
tracking Enable IP port security to learn static IP address learning on a port.
port-security (Optional) Enable IP source guard with IP and MAC address filtering.
If you do not enter the port-security keyword, IP source guard with IP
address filtering is enabled.
Release Modification
12.2(53)SE2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals