Cisco Catalyst 3750-X Command Reference

2-90
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
cisp enable
cisp enable
Use the cisp enable global configuration command to enable Client Information Signalling Protocol
(CISP) on a switch so that it acts as an authenticator to a supplicant switch.
cisp enable
no cisp enable
Syntax Description
Defaults There is no default setting.
Command Modes Global configuration
Command History
Usage Guidelines The link between the authenticator and supplicant switch is a trunk. When you enable VTP on both
switches, the VTP domain name must be the same, and the VTP mode must be server.
When you configure VTP mode, to avoid the MD5 checksum mismatch error, verify that:
• VLANs are not configured on two different.switches, which can be caused by two VTP servers in
the same domain.
• Both switches have the different configuration revision numbers.
Examples This example shows how to enable CISP:
switch(config)# cisp enable
Related Commands
cisp enable Enable CISP.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
dot1x credentials (global
configuration) profile
Configures a profile on a supplicant switch.
show cisp Displays CISP information for a specified interface.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing