2-156
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
device-sensor filter-list
device-sensor filter-list
To create a CDP or Link Layer Discovery Protocol (LLPD) filter list that contains a list of
Type-Length-Value (TLV) fields to be included or excluded in the Device Sensor output, use the
device-sensor filter-list command in global configuration mode. To remove the filter list, use the no
form of this command.
device-sensor filter-list cdp | lldp list list-name
no device-sensor filter-list cdp | lldp list list-name
Syntax Description
Command Default Protocol TLV fields filter list is not available.
Command Modes Global configuration (config)
Command History
Usage Guidelines Use the device-sensor filter-list command to configure the name of the protocol filter list and enter into
discovery protocol sensor configuration mode. You can configure the list of TLVs in discovery protocol
sensor configuration mode using the tlv {name tlv-name | number tlv-number} command. Use the name
tlv-name keyword-argument pair to specify the name of the TLV. Enter ? to query the available TLV
names or refer to the following tables.
list Contains a discovery protocol filter list.
list-name Name of the filter list.
Release Modification
15.0(1)SE1 This command was introduced.
Table 2-1 CDP TLV Names
CDP TLV Name Description
Global configuration mode
app Enables application TLV
forward Forwards CDP packets to another interface
location Enables location information
Interface configuration mode
app Enables application TLV
location Enables location information
server-location Enables CDP location server on the interface.
To Next Page
Loading...
Need help?
General
