Cisco Catalyst 3750-X Command Reference

C-39
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix C Catalyst 3750-X and 3560-X Show Platform Commands
show platform stack manager
show platform stack manager
Use the show platform stack manager privileged EXEC command to display platform-dependent
switch-stack information.
show platform stack manager {all | counters | trace [sdp [reverse] | state [reverse]]}
Note This command is supported only on Catalyst 3750-X switches.
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines Use this command only when you are working directly with your technical support representative while
troubleshooting a problem. Do not use this command unless your technical support representative asks
you to do so.
The summary information about the switch stack shows these states:
• Waiting—A switch is booting up and waiting for communication from other switches in the stack.
The switch has not yet determined whether or not it is a stack master.
Stack members not participating in a stack master election remain in the waiting state until the stack
master is elected and ready.
• Initializing—A switch has determined whether its stack master status. If it is not the stack master,
it is receiving its system- and interface-level configuration from the stack master and loading it.
• Ready—The member has completed loading the system- and interface-level configurations and can
forward traffic.
• Master Re-Init—The state immediately after a master re-election and a different member is elected
master. The new master is re-initializing its configuration. This state applies only to the new master.
all Display all information for the entire switch stack.
counters Display the stack manager counters.
trace [sdp [reverse]] Display trace information. The keywords have these meanings:
• sdp—(Optional) Display Stack Discovery Protocol (SDP) information.
• reverse—(Optional) Display trace information in reverse chronological
order (from recent to older chronological sequence).
trace [state [reverse]] Display trace information. The keywords have these meanings:
• state—(Optional) Display stack state machine information.
• reverse—(Optional) Display trace information in reverse chronological
order (from recent to older chronological sequence).
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing