EasyManuals Logo

Cisco Catalyst 3750-X Command Reference

Cisco Catalyst 3750-X
1244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1127 background imageLoading...
Page #1127 background image
B-65
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform phy
debug platform phy
Use the debug platform phy privileged EXEC command to enable debugging of PHY driver
information. Use the no form of this command to disable debugging.
debug platform phy {automdix | cablediag | dual-purpose | flcd {configure | ipc | iter | trace} |
flowcontrol | forced | init-seq | link-status | read | sfp | show-controller | speed | write |
xenpak}
no debug platform phy {automdix | cablediag | dual-purpose | flcd {configure | ipc | iter | trace}
| flowcontrol | forced | init-seq | link-status | read | sfp | show-controller | speed | write |
xenpak}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
automdix Display PHY automatic medium-dependent interface crossover (auto-MDIX)
debug messages.
cablediag Display PHY cable-diagnostic debug messages.
dual-purpose Display PHY dual-purpose event debug messages.
flcd {
configure | ipc |
iter | trace}
Display PHY FLCD debug messages. The keywords have these meanings:
configure—Display PHY configure debug messages.
ipc—Display Interprocess Communication Protocol (IPC) debug
messages.
iter—Display iter debug messages.
trace—Display trace debug messages.
flowcontrol Display PHY flowcontrol debug messages.
forced Display PHY forced-mode debug messages.
init-seq Display PHY initialization-sequence debug messages.
link-status Display PHY link-status debug messages.
read Display PHY-read debug messages.
sfp Display PHY small form-factor pluggable (SFP) modules debug messages.
show-controller Display PHY show-controller debug messages.
speed Display PHY speed-change debug messages.
write Display PHY-write debug messages.
xenpak Display PHY XENPAK debug messages
Release Modification
12.2(53)SE2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals