Name: Cisco Catalyst 3750-X
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2-955

Catalyst 3750-X and 3560-X Switch Command Reference

OL-29704-01

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

switchport voice detect

Use the switchport voice detect interface configuration command on the switch stack or on a standalone

switch to detect and recognize a Cisco IP phone. Use the no form of this command to return to the default

setting.

switchport voice detect cisco-phone [full-duplex]

no switchport voice detect cisco-phone [full-duplex]

Note This command is not supported on switches running the LAN base feature set.

Syntax Description

Command History

Usage Guidelines Use this command to detect and recognize a Cisco IP phone. The Cisco IP phone must be powered by

the switch with Power over Ethernet (PoE). If the phone is powered externally, the switch port is

disabled.

Examples This example shows how to enable detection and recognition of a Cisco IP phone on the switch:

Switch(config)# interface gigabitethernet1/0/1

Switch(config-if)# switchport voice detect cisco-phone

This example shows how to disable detection and recognition of a Cisco IP phone on the switch:

Switch(config)# interface gigabitethernet1/0/1

Switch(config-if)# no switchport voice detect cisco-phone

You can verify your settings by entering the show run interfaces interface-id privileged EXEC

command.

cisco-phone Configure the switch to detect and recognize a Cisco IP phone.

full-duplex (optional) Configure the switch to only accept a full-duplex Cisco IP phone.

Release Modification

12.2(53)SE2 This command was introduced.

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

General