Cisco Catalyst 3750-X Command Reference

2-937
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
switchport nonegotiate
switchport nonegotiate
Use the switchport nonegotiate interface configuration command on the switch stack or on a standalone
switch to specify that Dynamic Trunking Protocol (DTP) negotiation packets are not sent on the Layer 2
interface. The switch does not engage in DTP negotiation on this interface. Use the no form of this
command to return to the default setting.
switchport nonegotiate
no switchport nonegotiate
Syntax Description This command has no arguments or keywords.
Defaults The default is to use DTP negotiation to learn the trunking status.
Command Modes Interface configuration
Command History
Usage Guidelines The no form of the switchport nonegotiate command removes nonegotiate status.
This command is valid only when the interface switchport mode is access or trunk (configured by using
the switchport mode access or the switchport mode trunk interface configuration command). This
command returns an error if you attempt to execute it in dynamic (auto or desirable) mode.
Internetworking devices that do not support DTP might forward DTP frames improperly and cause
misconfigurations. To avoid this, you should turn off DTP by using the switchport no negotiate
command to configure the interfaces connected to devices that do not support DTP to not forward DTP
frames.
When you enter the switchport nonegotiate command, DTP negotiation packets are not sent on the
interface. The device does or does not trunk according to the mode parameter: access or trunk.
• If you do not intend to trunk across those links, use the switchport mode access interface
configuration command to disable trunking.
• To enable trunking on a device that does not support DTP, use the switchport mode trunk and
switchport nonegotiate interface configuration commands to cause the interface to become a trunk
but to not generate DTP frames.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing